Troubleshooting - Reloop terminal mix 4 Mode D'emploi

6.3 Troubleshooting

If a problem should arise while using Reloop Terminal Mix 4 the following chart is the first drop-in center:
sYMPTOMs
The device does not receive any
power when turning it on via the On/
Off Button -B44-.
The controller's LEDs are only wea-
kly lit and the device does not react.
Not all outputs of the integrated
audio interface can be selected in
the DJ software.
The audio interface's sound is
distorted.
There is a problem that is not listed
here.
POssiBle CAUses
USB cable is not connected correctly.
The power supply is not sufficient.
The ASIO driver is not installed correctly.
- The ASIO driver is not being used.
- The performance settings do not corres-
pond to the computer's capacity.
Various causes.
CORReCTive MeAsURes
Check whether the USB cable is connected to a USB
port of your computer and the USB port of Terminal
Mix 4 -B45-.
Please install the ASIO driver again. To do so please
also read the paragraph "ASIO Driver Installation" in
the chapter "Computer configuration".
Bitte installieren Sie den ASIO-Treiber erneut. Lesen
Sie dazu bitte den Abschnitt „ASIO Treiber-Installati-
on" des Kapitels „Computer-Konfiguration".
- Please make sure that the ASIO driver is installed
and is also being used. To do so please read the
paragraph "ASIO Driver Installation" in the chapter
"Computer Configuration".
- It is also possible that in the ASIO driver's settings
the available computer capacity has to be re-
configured. To do so open the Reloop ASIO settings
and increase the "ASIO Buffer".
Visit the website www.reloopdj.com/forum to get
support for your Reloop products.
31