Troubleshooting; Technical Specifications - Reloop beatmix Mode D'emploi

6.3 Troubleshooting

If a problem should arise while using Reloop Beatmix the following chart is the first drop-in center:
SYMPTOMS
The device does not receive any
power.
The controller's LEDs are only wea-
kly lit and the device does not react.
Not all outputs of the integrated
audio interface can be selected in
the DJ software.
The audio interface's sound is
distorted.
There is a problem that is not listed
here.

6.4 Technical Specifications

The following specifications are not verified by Global Distribution GmbH in terms of plausibility and accuracy:
Channel Separation ( crosstalk) : < 70dB
Frequency Response : 20~20KHz (+/- 2dB)
Input Impedance Headphones : 32OM
ANALOG
Master Outputs: 1.0V (+/- 0.2V)
Headphone Outputs: 600mV
THD+N
Unbalanced Outputs: 0.05%
Headphone Outputs: 0.05%
Frequency Response: 20 Hz - 20 KHz (+/- 1.5 dB)
Reloop Distribution
Global Distribution GmbH, Schuckertstrasse 28, 48153 Münster / Germany
Fax: +49.251.6099368
Subject to technical alterations.
Illustrations similar to original product.
Misprints excepted.
POSSIBLE CAUSES
USB cable is not connected correctly.
The power supply is not sufficient.
The ASIO driver is not installed correctly.
The ASIO driver is not being used.
The performance settings do not correspond
to the computer's capacity.
Various causes.
CORRECTIvE MEASURES
Check whether the USB cable is connected to a USB
port of your computer and the USB port of Beatmix
-B33-.
Please make sure that your USB port disposes of
sufficient voltage to supply the device with power.
Please install the ASIO driver again. To do so please
also read the paragraph "ASIO Driver Installation" in
the chapter "Computer configuration".
Please make sure that the ASIO driver is installed and
is also being used. To do so please read the paragraph
"ASIO Driver Installation" in the chapter "Computer
Configuration".
It is also possible that in the ASIO driver's settings
the available computer capacity has to be re-confi-
gured. To do so open the Reloop ASIO settings and
increase the "ASIO Buffer".
Visit the website www.reloopdj.com/forum to get sup-
port for your Reloop products.
21