Fm/Am Tuning; Overview; Fm/Am Tuning Operations; Preset Fm/Am Stations - Yamaha RX-V365 Mode D'emploi

Overview

You can use two tuning modes to tune into a desired FM/
AM station:
■
Frequency tuning mode
You can search or specify the frequency of the desired
FM/AM station automatically or manually (see "FM/AM
tuning operations" on this page).
■
Preset tuning mode
You can preset the desired FM/AM station in advance, and
then recall the station by specifying the preset group and
number (see "Selecting preset stations" on page 28).
Note
• Orient the connected AM loop antenna, or adjust the position of the end
of the indoor FM antenna for the best reception.

FM/AM tuning operations

1
Press NINPUT l / h repeatedly so that
"TUNER" is displayed on the front panel
display.
2
Press GBAND to select the reception band
(FM or AM).
3
To search the station automatically, press
ITUNING AUTO/MAN'L so that the AUTO
indicator lights up on the front panel display.
To search the station manually, press
ITUNING AUTO/MAN'L again so that the
AUTO indicator disappears from the front
panel display.
Lights up during automatic tuning
A AM 1440 kHz
No colon (:)
If a colon (:) appears on the front panel display,
automatic/manual tuning is not possible. Press
DEDIT PRESET/TUNING to turn the colon (:)
off.
4
To begin automatic tuning, press
FPRESET/TUNING l / h once. To tune
into the desired station manually, press
FPRESET/TUNING l / h repeatedly.
When this unit is tuned into a station, the TUNED
indicator lights up and the frequency of the received
station is shown on the front panel display.
• To tune into a higher frequency, press
FPRESET/TUNING h.

FM/AM tuning

Preset FM/AM stations

Use this feature to store up to 40 stations (A1 to E8: 8
preset station numbers in each of 5 preset station groups).
Preset the desired stations to this unit by using the
automatic or manual station preset.
Automatic station preset
You can use the automatic preset tuning feature to store up
to 40 FM stations with strong signals in order.
1
2
3
AUTO
y
• You can select the preset station group and the preset station number
where the first received station will be stored by pressing EA/B/C/D/E
and then FPRESET/TUNING l / h.
Notes
• Any stored station data existing under a preset station number is cleared
when you store a new station under the same preset station number.
• Only FM stations with sufficient signal strength are stored automatically
by automatic preset tuning. If the station you want to store is weak in
signal strength, tune it manually and store it as described in "Manual
station preset" on page 28.
• Only Radio Data System broadcasting station are stored automatically by
automatic preset tuning (Europe model only).
• To tune into a lower frequency, press FPRESET/
TUNING l.
Note
• If the signal from the station you want to select is weak, tune into it
manually.
Press NINPUT l / h repeatedly so that
"TUNER" is displayed on the front panel
display.
Press GBAND to select "FM" as the
reception band.
Press and hold HMEMORY for more than 3
seconds.
The preset station number as well as the MEMORY
and AUTO indicators flashes. After approximately 5
seconds, automatic presetting status from the current
frequency and proceeds toward the higher
frequencies.
A1:FM 87.50MHz
Flashes
When automatic preset tuning is completed, the front
panel display shows the frequency of the last preset
station.
Flashes
AUTO MEMORY
27
En