Additional Information; Troubleshooting - Yamaha RX-V365 Mode D'emploi

ADDITIONAL INFORMATION

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
■
General
Problem
This unit fails to turn
on or enters the
standby mode soon
after the power is
turned on.
No sound
The sound suddenly
goes off.
Sound is heard from
the speaker on one
side only.
38
En

Troubleshooting

Cause
The power cable is not connected or the
plug is not completely inserted.
The protection circuitry has been
activated.
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
Incorrect input or output cable
connections.
No appropriate Audio input jack select has
been set.
No appropriate input source has been
selected.
Speaker connections are not secure.
The front speakers to be used have not
been selected properly.
The volume is turned down.
The sound is muted.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
Audio signals input at the HDMI jack are
not output from any speaker terminals.
The setting of the connected component is
improper.
The protection circuitry has been activated
because of a short circuit, etc.
The sleep timer has turned off this unit.
The sound is muted.
Incorrect cable connections.
Incorrect settings in "SP LEVEL."
Remedy
Connect the power cable firmly.
Make sure that all speaker wire connections on this
unit and on all speakers are secure and that the wire
for each connection does not touch anything other
than its respective connection.
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and then
use it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Set an appropriate Audio input jack select.
Select an appropriate input source with
N INPUT l / h on the front panel (or the input
selector buttons (e) on the remote control).
Secure the connections.
Select the front speakers with CSPEAKERS.
Turn up the volume.
Press hMUTE or gVOLUME +/– on the remote
control to resume audio output and then adjust the
volume.
Play a source whose signals can be reproduced by this
unit.
Make an analog or digital connection beside the
HDMI connection.
Make an appropriate setting following the instruction
manual of the connected component.
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Press hMUTE or gVOLUME +/– on the remote
control to resume audio output.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust the "SP LEVEL" settings.
See
page
—
9
—
11-13
36
18, 19
9
19
—
20
—
—
—
—
—
20
11-14
33