Yamaha RX-V365 Mode D'emploi page 32

FM/AM tuning
Manual station preset
Use this feature to store the FM or AM stations manually.
1
Tune into a station.
See page 27 for using instructions.
2
Press HMEMORY.
The MEMORY indicator flashes on the front panel
display for approximately 30 seconds.
3
Press EA/B/C/D/E and FPRESET/TUNING
l / h repeatedly to select a preset station
group and number (A1 to E8) while the
MEMORY indicator is flashing.
Check that the colon (:) appears on the front panel
display.
• To select a higher preset station group and number,
press FPRESET/TUNING h.
• To select a lower preset station group and number,
press FPRESET/TUNING l.
C3 AM
:
Preset station group and number
4
Press HMEMORY while the MEMORY
indicator is flashing.
The station band and frequency appear on the front
panel display with the preset station group and
number you have selected.
C3 AM
:
The displayed station has been stored as C3.
Selecting preset stations
You can tune into any desired station simply by selecting
the preset station group and number under which it is
stored.
When performing this operation with the remote
control, press eTUNER to select "TUNER" as the
input source.
1
Press EA/B/C/D/E (or jA/B/C/D/E)
repeatedly to select the desired preset
station group (A to E).
The preset station group letter appears on the front
panel display and changes each time you press the
button.
28
En
Flashes
TUNED MEMORY
630 kHz
TUNED
630 kHz
2
Press FPRESET/TUNING l / h (or
iPRESET l / h) to select the desired
preset station number (1 to 8).
The preset station group and number, along with
station band and frequency, appear on the front panel
display.
Exchanging preset stations
You can exchange the assignments of two preset stations
between the two. The example below describes the
procedure to exchange preset station "E1" and "A5."
1
Select preset station "E1" using EA/B/C/D/E
and FPRESET/TUNING l / h.
See "Selecting preset stations" on this page.
2
Press and hold DEDIT PRESET/TUNING
for more than 3 seconds.
"E1" and the MEMORY indicator flash on the front
panel display.
3
Select preset station "A5" using EA/B/C/D/E
and FPRESET/TUNING l / h.
"A5" and the MEMORY indicator flash on the front
panel display.
See "Selecting preset stations" on this page.
:
A5 FM 90.50MHz
Flashes
4
Press DEDIT PRESET/TUNING again.
"EXCHANGE E1-A5" appears on the front panel
display and the assignments of the two preset stations
are exchanged.
Flashes
MEMORY