Yamaha RX-V365 Mode D'emploi page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connections
Speakers
a Front speaker (A) Right*
b Front speaker (A) Left*
c Surround speaker Right
d Surround speaker Left
e Center speaker
f Front speaker (B) Right*
g Front speaker (B) Left*
h Subwoofer
* You can select the front speaker set from Front speakers (A) and Front
speakers (B) by pressing CSPEAKERS repeatedly. See page 19 for
details.
Connect speaker cables to each speaker
Cables are colored or shaped differently, perhaps with a
stripe, groove or ridge. Connect the striped (grooved, etc.)
cable to the "+" (red) terminals of your speaker. Connect
the plain cable to the "–" (black) terminals.
Before connecting to the SPEAKERS
terminal
A speaker cord is actually a pair of insulated cables
running side by side.
Remove approximately 10 mm (3/8") of insulation
from the end of each speaker cable and then
twist the bare wires of the cable together to
prevent short circuits.
10 mm (3/8")
10
En
Jacks on this unit
FRONT A (R)
FRONT A (L)
SURROUND (R)
SURROUND (L)
CENTER
FRONT B (R)
FRONT B (L)
SUBWOOFER
Connecting to the FRONT A terminals
2
1
3
1
Loosen the knob.
2
Insert the bare end of the speaker wire into
the slit on the terminal.
3
Tighten the knob to secure the wire.
Connecting to the FRONT B, CENTER, and
SURROUND terminals
1
Press down the tab.
2
Insert the bare end of the speaker wire into
the hole on the terminal.
3
Release the tab to secure the wire.
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)

Publicité

Table des Matières
loading

Table des Matières