Connecting Video Components - Yamaha RX-V365 Mode D'emploi

Connecting video components

Information on jacks and cable plugs
Audio jacks and cable plugs
DIGITAL AUDIO
AUDIO
L R
COAXIAL
(White) (Red) (Orange)
L R
Left and right Coaxial
analog audio digital audio
cable plugs cable plug
AUDIO jacks
For conventional analog audio signals transmitted via left
and right analog audio cables. Connect red plugs to the
right jacks and white plugs to the left jacks.
COAXIAL jack
For digital audio signals transmitted via coaxial digital
audio cable.
OPTICAL jacks
For digital audio signals transmitted via optical digital
audio cables.
Notes
• You can use the digital jacks to input PCM, Dolby Digital, and DTS
bitstreams. All digital input jacks are compatible with digital signals with
up to 96 kHz of sampling frequency.
• This unit handles digital and analog signals independently. Thus audio
signals input at the digital jacks are not output at the analog AUDIO OUT
(REC) jack.
Video jacks and cable plugs
VIDEO
(Yellow) (Green)
V
Composite
video cable
plug
DIGITAL AUDIO
OPTICAL
O
C
Optical
digital
audio cable
plug
COMPONENT VIDEO
Y P P
B R
(Blue) (Red)
Y P P
B R
Component
video cable
plugs
VIDEO jacks
For conventional composite video signals transmitted via
composite video cables.
COMPONENT VIDEO jacks
For component signals, separated into the luminance (Y)
and chrominance (P , P ) video signals transmitted on
B R
separate wires of component video cables.
Video signal flow for MONITOR OUT
Input
P
R
COMPONENT
P
B
VIDEO
Y
VIDEO
Information on HDMI™
Audio signals input at the HDMI jack are not output
from any speaker terminals but output from the
connected video monitor. To enjoy the sound from
speakers connected to this unit,
– make an analog or digital connection besides the
HDMI connection (see page 13).
– mute the volume of the connected video monitor.
You can play back pictures by connecting your video
monitor and video source component to this unit using
HDMI connections.
At that time, audio/video signals output from the
connected component (such as DVD player etc.) are
output to the connected video monitor only when this unit
is turned on and set to the input source (DVD or DTV/
CBL).
Furthermore, available audio/video signals depend on the
specification of the connected video monitor. Refer to the
instruction manual of each connected component.
■
HDMI jack and cable plug
HDMI
y
• We recommend using an HDMI cable shorter than 5 meters (16 feet)
with the HDMI logo printed on it.
• Use a conversion cable (HDMI jack ↔ DVI-D jack) to connect this unit
to other DVI components.
Using the AUDIO OUT REC jack
You can record the audio signal output at the AUDIO
OUT (REC) jack by using the recording components.
Note
• Check the copyright laws in your country to record from CDs, radio, etc.
Recording of copyrighted material may infringe copyright laws.
Connections
Output
(MONITOR OUT)
P
R
P
B
Y
HDMI cable plug
11
En