Reloop IQ2+ Mode D'emploi page 25

5. Connect an MP3 player (for example) to the AUX input (3.5 mm jack) -38-. If
you want to play tracks from your MP3 player via the mixer, the CD1/AUX
input switch -37- has to be in the "AUX" position. If you want to play tracks
from the CD player connected to channel A via your mixer, the CD1/AUX
input switch -37- has to be in the "CD1" position.
NOTE!
The function described above is only available for channel A.
6. Connect the output for the send signal -33- to the input of your effect device
and sampler respectively. Connect the output of your effect device and
sampler respectively to the input for the return signal -32-.
7. If required connect your CD player's fader start cords to the input for the
fader start function -28-.
NOTE!
The input "A" for the fader start function -28- is assigned to channel A and
the input "B" for the fader start function is asigned to channel "B".
8. Connect your stereo system to the master output (RCA) -35- or to the
symmetrical master output (6.3 mm jack) -36-.
9. Connect a recording device of your choice to the REC output (RCA) -34-.
(only available for Reloop IQ2+ USB)
10. Connect the USB port 1 -46- to your computer's USB port and connect the
USB port 2 -47- to another USB port of your computer.
NOTE!
Please also follow your computer's instruction manual regarding this matter.
11. Connect the mains cord to the input for the mains cord -26-. Connect the
mains cord to an outlet.
25