Setting The System; Step 1: Turn On The Power And Select The Dvd Input; Step 2: Adjust The Clock - Yamaha MCR-E810 Mode D'emploi

Before starting playback operation, follow the procedure below to configure the system settings.
Step 1: Turn on the power and
select the DVD input
STANDBY/ON
STANDBY/ON
1
5
9
DVD/CD
DVD/CD
TAPE/MD
SUBTITLE ANGLE
1
Turn on your TV and then press STANDBY/
ON to turn on the receiver.
If the DVD player is connected to the receiver with
the system control cable, the DVD player turns on
automatically. Otherwise, press STANDBY/ON on
the front panel of the DVD player to turn on it.
The front panel display of each component lights up.
2
Press DVD/CD to select "DVD/CD" as an
input source.
3
On your TV, select the input to which the DVD
player is connected (EXT1, AV1, etc.). For
details, refer to the manual supplied with
your TV.
The default screen appears on the TV screen.
Note
If the picture is distorted on your TV, the color system (NTSC and
PAL) setting of the DVD player may not match your TV.
To switch the color system setting in such case, press
AUDIO while the disc tray is open.

Setting the System

POWER
TV
2 3 4
6 7 8
SCAN DIMMER
0
REPEAT A B
SLEEP
TUNER BAND
AUX/TV DOCK
ZOOM AUDIO
and then

Step 2: Adjust the clock

DISPLAY
NATURAL SOUND STEREO RECEIVER RX-E810
DISPLAY MEMORY AUTO/MAN'L
TIMER
TIME ADJ TIMER
BASS TREBLE
STANDBY/ON
PHONES
TIME ADJ PRESET/BAND
1
Press DISPLAY on the front panel of the
receiver.
"Clock Time" appears in the front panel display for a
few seconds, and then "Set Clock" appears.
2
Press TIME ADJ for about two seconds to
enter the clock setting mode.
3
To set the hour setting ahead, press HOUR
repeatedly. To set the hour setting backward,
press HOUR repeatedly while holding down
PRESET/BAND.
4
To set the minute setting ahead, press MIN
repeatedly. To set the minute setting
backward, press MIN repeatedly while
holding down PRESET/BAND.
SETTING THE SYSTEM
HOUR MIN
PURE DIRECT
PRESET/BAND PRESET/TUNING
VOLUME
HOUR MIN
INPUT
BALANCE
L R
MIN MAX
19
En