Troubleshooting; Receiver (Rx-E810) - Yamaha MCR-E810 Mode D'emploi

TROUBLESHOOTING

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
YAMAHA dealer or service center.

Receiver (RX-E810)

General
Problem
The receiver fails to
turn on or enters the
standby mode soon
after the power is
turned on.
No sound
The sound suddenly
goes off.
Sound is heard from
the speaker on one
side only.
There is noise
interference from
digital or radio
frequency equipment.
58
En
Troubleshooting
Cause
The power cable is not connected or the
plug is not completely inserted.
The receiver has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
Incorrect input or output cable
connections.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down.
Signals the receiver cannot reproduce are
being input from a source component,
such as a CD-ROM.
The timer has turned off the receiver.
Incorrect cable connections.
The receiver is too close to the digital or
high-frequency equipment.
Remedy
Connect the power cable firmly.
Set the receiver to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and then
use it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Select an appropriate input source with the INPUT
selector on the front panel (or the input selection keys
on the remote control).
Secure the connections.
Turn up the volume.
Play a source whose signals can be reproduced by the
receiver.
Turn on the receiver, and play the source again.
Connect the cables properly. If the problem persists,
the cables may be defective.
Move the receiver further away from such equipment.
See
page
18
—
12
—
13
—
—
—
13
—