Setting/Activating The Timer; Invoke The Info Display - Nordmann Engineering AT4D Instructions D'installation Et D'exploitation

5.8

Setting/activating the timer

5.9

Invoke the info display

Via the steam bath control a timer controlled bathing operation can be con-
figured and activated. If the timer is activated, the steam generator starts
at the set time of day and runs for the set duration. After the bathing time
has elapsed the timer is deactivated and must newly be activated for each
day. To configure the timer proceed as follows:
42°C
Standby
45min
08:19
15:00 :
45min
08:19
Standby
09:00
42°C
Standby
45min
In the standby operating display tap on the
key.
Using the and keys beside the symbol
set the hour (left pair of keys) and the
minutes (right pair of keys) of the time of day
at which the steam generator should start.
Using the and keys beside the symbol
set the desired bathing time in minutes
(setting range: 5...240 minutes).
Then, activate the timer by taping on the
key (key is represented inversely).
After all adjustments are done save the set-
tings with the key.
The inversely represented
standby operating display indicates that the
timer is active. The set time of day and the
starting time is shown. The steam genera-
tor will start at the set time of day for the set
duration.
In the operating display tap on the
key in the
key.
45