Xylem Vogel L Serie Instructions De Montage page 4

EC Declaration of Conformity
(according to EC Directive on Machinery 2006/42/EC, Annex II A)
The manufacturer,
Xylem Water Solutions Austria GmbH
Ernst Vogel-Strasse 2
2000 Stockerau
Austria
of the pumps from the standard product line hereby declares:
L65-315, L80-315, L80-400, L100-160, L100-200, L100-250, L100-315, L100-400, L125-200,
L125-250, L125-270, L125-315, L125-400, L150-250, L150-315, L150-400
LN32-125, LN32-160, LN32-200, LN40-125, LN40-160, LN40-200, LN40-250, LN50-125, LN50-
160, LN50-200, LN50-250, LN65-125, LN65-160, LN65-200, LN65-250, LN80-160, LN80-200,
LN80-250
The supplied aggregates meet the relevant regulations of the EC Directive on Machinery, 2006/42/EC.
The three-phase electric motor supplied at the same time meets the relevant regulations of Directive
2004/108/EC.
Special technical documentation has been prepared, in accordance with Annex VII A.
If necessary, we can submit the above-listed special technical documentation, in electronic form on a data
storage medium, to the relevant authorities.
The above-listed special documentation can be requested at the following address:
Dipl. Ing. Gerhard Fasching
Abtlg. Research & Development
Xylem Water Solutions Austria GmbH
Ernst Vogel-Strasse 2
2000 Stockerau
Austria
Among others, the following harmonised standards have been applied:
EN 809 :1998+A1:2009+AC:2010(D)
EN 953 :1997+A1:2009(D)
EN ISO 12100 :2010(D)
EN 60204-1 :2006/A1:2009 D
A change to an aggregate which was not approved by us invalidates this declaration. This also applies in
the case that the aggregate is installed in equipment that does not have the declaration of conformity in
accordance with the Directive on Machinery, 2006/42/EC.
Stockerau, 02.05.2011
(valid only for ITT Austria aggregate supplied in its entirety)
................................................................................................
Dir. Ing. Peter Steinbach
Production manager