Operating Instructions - Fisher & Paykel COOLDRAWER RB36S Guide D'utilisation

Before placing food in the drawer
Clean the inside of the appliance with warm water and a little liquid detergent to
● ●
remove manufacturing and transportation dust.
Ideally, allow the drawer to run empty overnight, or for at least 5 hours, to allow it to
● ●
cool to the appropriate temperature before placing food inside.
The appliance may have an odor initially, but this will go when the compartment has
● ●
cooled sufficiently.
Energy efficiency
For the most energy efficient use of your appliance:
Ensure your CoolDrawer™ has adequate ventilation as recommended in the
● ●
installation instructions.
Allow good clearances in front of air ducts within the CoolDrawer™.
● ●
Cool hot foods down before placing them in the CoolDrawer™.
● ●
Do not overfill the CoolDrawer™.
● ●
Keep door openings to a minimum.
● ●
Select a temperature setting that isn't too cold.
● ●
If your appliance is turned off for any reason, wait 10 minutes before turning it back on.
This will allow the refrigeration system pressures to equalize before restarting.
The temperature of the drawer is accurately controlled and does not change with the
temperature or humidity of the surroundings; whether summer or winter.
To use the control panel
Unlock the control panel, press
1
Match the type of items you wish to store in the CoolDrawer™ to the relevant
2
storage environment.
To select between different storage environments press
3
mode, which best represents the food items you wish to store.
The food mode icon selected will flash until the CoolDrawer™ reaches a suitable
4
temperature for food to be added (this will take approximately 1 – 6 hours).
Selecting the food mode
Select the desired compartment.
● ●
Press to scroll through the available modes. The food mode will illuminate as you
● ●
scroll to indicate which mode is selected.
To adjust the temperature of your food mode
Press once to reduce the temperature. This will decrease the number of lights.
● ●
When all four lights on the left are showing, the coldest setting is selected.
Press once to increase the temperature. This will increase the number of lights.
● ●
When all four lights on the right are showing, the warmest setting is selected.
14

OPERATING INSTRUCTIONS

for 3 seconds. The icon will no longer be illuminated.
to scroll to the desired food