Medela Invia Liberty Mode D'emploi page 33

Dressing: - Check dressing for air leakage. Press firmly around the edges of the dressing, around the drain tube or on the
External Suction Interface (ESI).
- Apply some additional film dressing to seal the leaking area.
Connectors: - Ensure that the wound dressing tubing is connected properly to the Canister tube.
- Ensure that the canister tube is inserted straight into the pump.
Canister: - Ensure that the canister is properly inserted, release the canister and reposition.
- Ensure that the O-ring / gasket, placed beside the canister tubing on the pump is not missing. Additional O-ring is
available via Medela customer service.
Tubing: - Ensure that the tubing is not twisted, kinked or clamped.
- If the canister tube is clogged, change the tube.
Canister: - If canister is full or filter clogged, replace canister.
Recharge the battery either by placing the Invia Liberty Pump in the Docking Station or plug in the charger
to the electrical outlet port on the pump.
Remaining time of battery is approximately 15 minutes.
Change the canister, see chapter "Change Invia Liberty Canister and Invia Liberty Tubing".
Canister: - Release the canister and reposition.
Tubing: - Ensure that the tubing is not twisted, kinked or clamped.
Dressing: - Check dressing for air leakage. Press firmly around the edges of the dressing, around the drain tube or on the
Transfer Pad.
- Apply some additional film dressing to seal the leaking area.
Connectors: - Ensure that the wound dressing tubing is connected properly to the Canister tube.
- Ensure that the canister tube is inserted straight into the pump.
Canister: - Ensure that the canister is properly inserted, release the canister and reposition.
- Ensure that the O-ring / gasket, placed beside the canister tubing on the pump is not missing. Additional O-ring is
available via Medela representative.
Change canister, see chapter "Change Invia Liberty Canister and Invia Liberty Tubing"
Remarks / potential cause of fault
33