Conrad 190486 Mode D'emploi page 35

To determine the start-up sequence, we proceed as follows:
• Switch on the 16-channel running light control.
• Select the desired running light sequence with which the 16-channel running light control
should start upon activation wither with the switch at the remote control, or with the mode
button SW 2 on the board.
• To store the settings, hold down the mode button SW 2 until the LED display "LED1" is first
lit and then flashes. The light sequence is stored when the LED flashes.
RC
GND
UB
GND
USB TO UART
GND
RXD
TXD
SW 1 SW 2
RESET MODE
R22
U1
R24
5 - 18 VDC
Q1
C11
C10
LED1
R23
U2
L1
16 - K_Lauflicht_V11
Figure 8
R21
D3
C7
R1
R1
35