Model Assembly Continued - Horizon Hobby E-Flite Pulse 15e Manuel D'utilisation

Model Assembly Continued

Landing Gear Installation (Tail Dragger Option)
1. Install the main landing gear assembly (A) on the fuselage as shown using
2 screws (B).
2. Install the tail wheel (C) in the rudder mount as shown. Secure in place by
tightening the set screw (D) on the flat spot on the strut using a 1.5mm
hex wrench.
L di Landing Gear Installation (Tricycle Gear Option) G I t ll ti
1. Remove the 2 wing screws (A) from the wing and install the main gear (B)
on the wing.
2. Secure the main gear and wing into place with the 2 wing screws.
3. Install the nose gear (C) in the nose, tightening the set screw (D) on the fl at
spot on the strut using a 1.5mm hex wrench.
(T i l G O ti )
A
D
C
C
D
EN
B
A
B
7