Model Assembly Continued - Horizon Hobby E-Flite Pulse 15e Manuel D'utilisation

Model Assembly Continued

Required Adhesives:
Medium CA
Rudder Installation
1. Insert the z-bend (A) of the rudder linkage into the outermost hole of the
rudder control horn (B).
Tip: Inside the fuselage, move the rudder servo arm to full travel. This moves
the linkage rearward to give the most room to install the rudder.
2. Hold the fuselage with the rudder hinge slots faceing up as shown. Apply
medium CA (cyanoacrylate adhesive) in each hinge slot (C) so the CA fl ows
down into each slot.
3. Install the rudder post (D) in the fuselage plate hole and then slide the CA
hinges into the hinge slots of the fuselage.
4. When the CA is dry, gently pull on the rudder to ensure it is secure.
C
EN
B
A
D
5