Post Flight Checklist; Motor Service; Troubleshooting Guide As3X - Horizon Hobby E-Flite Pulse 15e Manuel D'utilisation

Post Flight Checklist

Disconnect the fl ight battery from the ESC (Required for Safety
1
and battery life).
2 Power OFF the transmitter.
3 Remove the fl ight battery from the aircraft.
4 Recharge the fl ight battery.

Motor Service

CAUTION: Always disconnect the fl ight battery before performing
motor service.
Disassembly
1. Remove the spinner nut (A), Spinner (B), Propeller nut (C), propeller (D),
spinner backplate (E) backplate (F), and cullet (G) from the motor shaft.
Note: a tool is required to remove the spinner nut.
2. Pull to remove the cowling which is held with magnets.
3. Remove the 4 screws (H) from the motor mount (I) and the fuselage.
4. Disconnect the motor wires from the ESC wires.
5. Remove the 4 screws (J) and motor (K) from the motor mount.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• The propeller size numbers (12 x 8) must face out from the motor for correct
propeller operation.
• A tool is required to tighten the lock nut on the collet.

Troubleshooting Guide AS3X

Problem Possible Cause
Damaged propeller or
spinner
Imbalanced propeller
Motor vibration
Oscillation
Loose receiver
Loose aircraft controls
Worn parts
Irregular servo movement
Trim is not at neutral
Sub-Trim is not at neutral
Inconsistent fl ight
performance
Aircraft was not kept im-
mobile for 5 seconds after
battery connection.
Incorrect response Incorrect direction settings
to the AS3X Control in the receiver, which can
Direction Test cause a crash
5 Repair or replace all damaged parts.
Store the fl ight battery apart from the aircraft and monitor the
6
battery charge.
Make note of the fl ight conditions and fl ight plan results, planning for
7
future fl ights.
A
Replace propeller or spinner
Balance the propeller. For more information, view John Redman's propeller balancing video at www.
horizonhobby.com
Replace parts or correctly align all parts and tighten fasteners as needed
Align and secure receiver in fuselage
Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Replace worn parts (especially propeller, spinner or servo)
Replace servo
If you adjust trim more than 8 clicks, adjust the clevis to remove trim
No Sub-Trim is allowed. Adjust the servo linkage
With the throttle stick in lowest position. Disconnect battery, then reconnect battery and keep the aircraft
still for 5 seconds
DO NOT fl y. Correct the direction settings (refer to the receiver manual), then fl y
D
E
F
B
C
I
H
Solution
G
J
K
15
EN