Model Assembly Continued - Horizon Hobby E-Flite Pulse 15e Manuel D'utilisation

EN

Model Assembly Continued

Propeller Installation
1. Attach the collet (A), backplate (B), spinner backplate (C) and propeller (D)
to the motor shaft (E) using the spinner nut (F).
IMPORTANT: The propeller size numbers (12 x 8) must face out from the motor
for correct propeller operation.
IMPORTANT: A tool is required to tighten the spinner nut on the collet.
2. Correctly align the spinner (H) and secure it on the collet using
the screw (I).
IMPORTANT: Ensure the spinner is fully connected to the spinner backplate for
safe operation.
When needed, disassemble in reverse order.
Optional Floats Installation
1. Remove the landing gear from the aircraft.
Tip: If removed, install the wing screws.
2. Turn the latch and remove the retainer from the fuselage slot.
3. Insert the front fl oat strut (as described), then the retainer, turning the
latch over the slot.
To complete fl oat set installation refer to instructions included with the optional
fl oats (EFLA550, sold separately).
8
D
B
C
H
I
F
A
E