Installation; What You Should Pay Attention To - ETNA A362KZT Mode D'emploi

installation

What you should pay attention to

EN 16
Safety instructions for installation
• T he electrical connection must comply with national and local
regulations.
• The appliance must always be earthed.
• T his appliance should only be connected by a registered
electrician.
• For connecting, use an approved cable (for example type HO7RR)
with the correct cable diameters appropriate for the connection.
The cable casing should be made of rubber.
• T he connection cable must hang freely and should not be fed
through a drawer.
• I f you want to make a fixed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is fitted in
the supply line.
• To avoid dangerous situations resulting from any damage to the
connecting cable, this should only be replaced by the manufacturer,
the manufacturer's service organisation or by qualified persons.
• T he worktop into which the hob is fitted should be flat.
• T he walls and the worktop around the appliance must be made of
heat-resistant (> 85°C) material. Even if the appliance itself does
not get hot, the heat from a hot pan could cause discolouration or
distortion to the wall or worktop.
• D amage caused by incorrect connection, incorrect use, or incorrect
fitting is not covered by the guarantee.
• The connection point, the wall socket and/or the plug must always
be accessible.