Table des Matières
Publicité
expect "0\r" timeout 2
done
error:
expect "8\r" or "7\r" or "6\r" or "4\r" or "3\r"
delay 2
done
Fichier d'exemple modem_f.cfg
#
# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F
#
# FUNCTIONS: Modem configuration file for many recent Hayes* compatible modems.
# This example uses the AT&F reset command to choose the factory defaults.
# This set up is preferred for modems with extended (&) commands. For early
# vintage modems, setup Z or Z0 is recommended. If your modem responds to
# the extended (&) commands and to factory default choices (&Fn), setup file
# F0 or F1 is recommended.
#
# * Trademark of Hayes Microcomputer Products, Inc.
#
# (C) COPYRIGHT International Business Machines Corp. 1996
# All Rights Reserved
# Licensed Materials – Property of IBM
#
# US Government Users Restricted Rights – Use, duplication or
# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
#
#
# If the modem has configuration switches, they should be set to the
# factory default settings.
ICDelay 1
DefaultTO 10
CallDelay 120
# AT Attention Code
# &F Reset to default profile
# E0 Turn echo off
# V0 Use numeric responses
# +++ Escape to command mode S0=2 Answer on second ring
# H0 Hang–up
#
#
#
#
# &C1 Detect CD
#
# %N Call–Out phone number %P Paging phone number
# %S Modem speed (available to users)
#
# Following are common responses from a wide range of modems:
# 16, 15, 12, 10, 5 and 1 are connection responses. Add others as required.
# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; 0=OK
#
# PROGRAMMING NOTE: No blanks between double quote marks (").
condout: send "AT&FQ0T\r"
B-12
ESCALA EPC610 et PL 600R Guide de l'utilisateur système
# Confirm command successful.
# RI Power On enabled.
# Handle unexpected modem
# responses.
, Inserts delay in dialing commands
Q0 Turn on responses
Q1 Turn off responses
S0=0 Automatic answer inhibit
X0=0 Limit modem response codes
T = Tone mode. When used as T\r, it is a
no op to maintain program synchronization
when modem may/will echo the commands.
&D2 Respond to DTR (often the default)
# Reset to factory defaults.
Publicité
Table des Matières
