Direct Current; Symbol; Safety Information - Amprobe AM-540 Mode D'emploi

SYMBOLS
X
Caution ! Risk of electric shock.
�
Caution! Refer to the explanation in this Manual
B
Alternating Current (AC)
F
Direct Current (DC)
The equipment is protected by double insulation or reinforced
T
insulation
J
Earth (Ground)
Audible tone
Battery
�
Complies with European Directives
�
Conforms to relevant Australian standards
)
Canadian Standards Association (NRTL/C)
Do not dispose of this product as unsorted municipal waste.
=
Contact a qualified recycler.

SAFETY INFORMATION

The Meter complies with:
IEC/EN 61010-1 3rd Edition Pollution Degree 2, Measurement Category IV 600V
and Measurement Category III 1000V
IEC/EN 61010-2-31 for test leads
EMC IEC/EN 61326-1
Measurement Category IV (CAT IV) is for measurements performed at the
source of the low-voltage installation. Examples are electricity meters and
measurements on primary overcurrent protection devices and ripple control
units.
Measurement Category III (CAT III) is for measurements performed in the
building installation. Examples are measurements on distribution boards,
circuit- breakers, wiring, including cables, bus-bars, junction boxes, switches,
2