Fulgor Milano FTHD 900 TC X Instructions Pour L'installation Et L'utilisation page 17

MAINTENANCE
* An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
* Particular care is due to the grease filter panel.
It can be removed by pushing its special handle
toward the back-side of the cooker hood and tur-
ning the filter downwards so to unfasten it from its
slot (Fig. 3B-4A).
To insert the filter just perform the opposite ope-
ration.
After 30 hours working (model SL-Module Luxury
version), the push button control panel will signal
the saturation of the grease filter by lighting all
the buttons. In the SLTC models (Touch Control
Version) the grease filter saturation is signalled
by the flashing of the two central push buttons
(Fig. 21C). Press the timer button to reset
The grease filter needs cleaning by regular hand-
washing or in dishwashers every two months at
least or depending on its use.
* In case the appliance is used in its filtering ver-
sion, the active coal filter (Fig. 16-20Z) needs to
be periodically replaced.
The coal filter can be removed by removing the
grease filter first (Fig. 4A-16B), and by pulling its
special plastic tongue until it is unfastened from
its slot. Re-insert the coal filter by operating in the
opposite way. The coal filter needs replacing de-
pending on the use, but however every six mon-
ths at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, while abra-
sive products should be avoided. For steel ap-
pliances specialized detergents are recommen-
ded (please follow the instructions indicated o the
product itself to obtain the desired results).
* Before replacing the lamps, disconnect the
appliance from the electric mains. Remove the
grease filter and the carbon filter, if it is inserted.
Once the burnt out bulb is localized, turn it anti-
clockwisely and replace it with a bulb of the same
type.
* If the supply cord is damaged, it must be re-
placed by the manufacturer or its sevice agent
or a similarly qualified person in order to avoid
a hazard.
* Substitution of the LED bar:
Using an appropriate tool, remove the LED bar
from its seat (refer to Fig. 13), disconnect it elec-
tronically using the appropriate connector then
substitute it with a LED bar with same charac-
teristics.
.
17