Fulgor Milano FTHD 900 TC X Instructions Pour L'installation Et L'utilisation page 15

Fixing the ornamental chimney
* Before fixing the chimney, place the electric fee-
ding equipment into the ornamental pipe and pro-
vide it with a hole for the air outlet if the appliance
is used in its sucking version.
Warning!
Before connecting the flexible exhausting pipe to
the motor, make sure the stop valve, which is on
the air outlet of the motor, can swing.
Sucking version
* Fix the pipe-bearing stirrup (Fig. 7Y) to the wall
or ceiling by using the proper reinforcements and
screws in equipment. Connect the cooker-hood
flange with the evacuation hole by using a proper
pipe.
Now mount the inferior chimney by inserting it
through the front side of the cooker hood and
then turning it down until it is fixed inside (Fig. 8).
Filtering version
* In the filtering version the air deviator is fixed
through the screws supplied (Fig. 9), by using the
holes which are on the back of the upper telesco-
pic section. Connect the flange of the appliance
with the air deviator through an appropriate pipe.
Connect the appliance with the electric mains.
Fix the upper chimney as indicated in bic. 9.
WORKING
FTHD 900 TC X - FTHD 1200 TC X (dis. 10)
A: Interruttore on/off luce
B: Interruttore on (I
C: Interruttore II
a
D: Interruttore III
a
E: Interruttore IV
a
F: Temporizzatore 10 minuti
FTHD 900 TC BKX - FTHD 900 TC WHX (Dis. 11)
A: interruttore ON/OFF luci
B: ON motore / aumento velocità
C: indicatori velocità
D: riduzione velocità / OFF motore
E: temporizzatore 10 min.
The touch control key allows the function desired
by touching the relative key.
15
velocità)/off motore
a
velocità
velocità
velocità