Electrical Connection; Connect Vent System - Thermador Masterpiece Serie Instructions D'installation

2. Mark with a pencil the lower mounting holes location.
3. Uninstall the hood assembly, and drill
pilot holes at marked locations.
4. Hang the range hood again on 2 upper mounting screws.
5. Level the range hood and tighten upper mounting
screws.
6. Install 2 - 5 x 45 mm lower mounting screws and
tighten. Use the optional wall anchors if needed.

Connect Vent System

1. Fit vent system over the exhaust outlet.
2. Measure from the bottom of the air deflector to the
bottom of the hood outlet. Cut the ductwork at the
measured dimension.
Wall
outlet
3. Seal connection with clamps.
4. Check that back draft dampers work properly.
Installation Instructions
⁄ " (4.8 mm)
3
16
Roof
outlet
Dimension
to measure

Electrical Connection

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
• Disconnect power.
• Remove terminal box cover.
• Remove the knockout in the terminal box cover and
install a UL listed or CSA approved
B
A
• Run home power supply cable through strain relief,
into terminal box.
F
A. Home power supply cable
B. UL listed or CSA approved
strain relief
C. Black wires
⁄ " strain relief.
1
2
C
A Juction Box
B Knockout
C Juction Box cover
B
A
D
C
E
D. UL listed wire connectors
E. White wires
F. Green (or bare) and yellow-green
ground wires
English | 15 |