Installation Instructions; Determine Installation Height - Thermador Masterpiece Serie Instructions D'installation

Assembly of the Transition
A minimum height clearance of 4
above the hood for transition mounting. See "General
Information" on page 8 for overall hood dimensions.
1. Depending on direction of discharge, align mounting
holes at base of transition with the mounting holes on
the top of the hood.
2. Fasten transition to hood using four (4)
sheet metal screws included with hood.
3. Seal connection between transition and hood with
aluminum tape. DO NOT use duct tape. Ensure that
the connection is completely sealed.
4. Remove tape holding damper closed.

Installation Instructions

⁄ '' (110 mm) is needed
5
16
⁄ '' (6 mm)
1
4
Installation Instructions
Installation

Determine installation height

20 ⁄ "
9
16
(522)
30" (762) min over a electric cooktop
30" (762) min over a gas cooktop
The figure above indicates a typical installation of the hood.
An optional chimney extension kit to reach 9'-12' (274 to
366 mm) may be purchased. Add or subtract chimney ex-
tensions as appropriate to accommodate ceiling height and
recommended hood height.
For gas cooktop & range installations: Mount the hood
so the bottom is at least 30" (76.2 cm) above the cooking
surface.
For electric/induction cooktop & range installations:
Mount the hood so the bottom is at least 30" (76.2 cm)
above the cooking surface.
NOTICE: The hood could incur some damage from heat
if a THERMADOR MASTERPIECE
ted with multiple burners at high settings under a hood that
is installed at minimum clearances.
series cooktop is opera-
®
English | 13 |