Electrical Wire Routing And Connection - Thermador HPIN42WS Instructions D'installation

Blower Wire Connection
1. Route the blower motor's plug connector to the hood.
Connect the blower's harness to the hood harness.
Electrical Wire Routing and
Connection
1. Remove the three (3) short screws from the junction
box cover and remove the cover.
2. Connect the power supply wires to the hood wires in
the following order: black to black, white to white, and
green wire to green ground screw on chassis. Use
spring type wire nuts.
• Wire nuts should be spring type wire nuts rated
for a minimum of two (2) #18 gauge wires and
maximum of four (4) #14 gauge wires, UL & CSA
rated to 600V and 302°F (150°C).
3. Replace the junction box cover and secure it with the
previously removed 3 short screws.
EXTNCB25W 25 ft. Remote and In-line
Blower Extension Cable (optional)
Parts Included
• 1 – 25ft cable
• 2 – Adapter Cables (NOT NEEDED for all models)
Blower Extension Cable Connection
The internal blower harness should be routed through the
knockout and secured with a 1'' (25.4 mm) strain relief.
The remote harness can then be connected to the blower
harness outside the unit.
NOTE: Cutting of the connector will void the warranty of
the appliance.
The blower extension cable is compatible with the
following In-line & Remote blowers:
Blower
Remote Blower
Remote Blower
Remote Blower
In-line Blower
In-line Blower
SKU
VTR630
VTR1030
VTR1330
VTI610
VTI1010
Page. 17