GRAUPNER MAXIE SPORT Instructions De Montage page 22

Please don't misunderstand the purpose of these notes. Our only intention is to make you aware
of the many dangers and hazards which can arise if you work carelessly or irresponsibly. If you
take reasonable care, model flying is a highly creative, instructive, enjoyable and relaxing pastime.
Introduction
The MAXIE SPORT provides an ideal combination of smooth, inherently stable flying characteristics and
high performance.
The kit is highly pre-fabricated. Nevertheless, the procedures described in these instructions should be
carried out with the greatest care in order to ensure that the model flies safely and successfully.
Electric power system and accessories
Power Motor
variant Order No.
Sport COMPACT 440 12 V
6522
High- COMPACT 490 16 V
performance
6523
It is important to obtain all the accessories required for your selected power variant before you start
construction, as the components will need to be trial-fitted and installed at the appropriate stage.
RC system
This model should only be flown with an FM radio control system with six or more channels, e.g. the mc-
19 to mc-24 RC sets. For more information about radio control system accessories please refer to the
main FS catalogue, or the operating instructions supplied with your radio control system.
Accessories
You will need the following additional components in order to operate the model:
2 ECO wing-mounting servos, C 3341
2 C 271 servo
1 Long output arm, two required, from
1 Servo extension lead, 750 mm
1 Servo extension lead, 1050 mm
1 Connector security clip, two required, from
2 Servo suppressor filter
1 R700 receiver
1 Receiver crystal
Building the model
Use UHU plus schnellfest, Order No. 962 (fast-setting epoxy), as adhesive throughout the construction of
this model, unless specifically stated otherwise in the building instructions.
Thoroughly sand all areas inside the fuselage where parts are to be glued.
All components should be trial-fitted and trimmed to fit accurately before they are glued to the model.
Where hole positions are marked, drill them before installing the parts.
Allow plenty of time for glued joints to set hard. The glue must be completely cured before you resume
construction.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
Folding propeller
Order No.
CAM FOLDING
PROP
1336.40.25 plus
aluminium spinner
9500.45K
CAM FOLDING
PROP
1336.45.25 plus
aluminium spinner,
9500.45K
Flight battery
Order No.
GRAUPNER LiPo
3 / 4300, 11.1 V / 4.3 Ah
7656.3
GRAUPNER LiPo
4 / 4300, 14.8 / 4.3 Ah
7656.4
Order No. 5120
Order No. 5107
Order No. 3941.10
Order No. 3935.75
Order No. 3935.105
Order No. 3503
Order No. 1040
Order No. 3551
Order No. 3265...
Speed controller
Order No.
GRAUPNER
GENIUS 40
2896
GRAUPNER
GENIUS 70
2897
22
09/2006