After-Sales Service; Technical Data; Automatic Programmes; Setting A Programme - CONSTRUCTA CN462250 Notice D'utilisation

Screw the lamp cover in place.
6.
Reassemble the appliance in the reverse order.
Switch the circuit breaker in the fuse box back on or plug in
7.
the mains plug.

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate bearing these numbers can
be found in the oven. You can make a note of the number of
your appliance and the telephone number of the after-sales
service in the space below to save time should it be required.
E no.
After-sales service O
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list..
Trust the expertise of the manufacturer, and rest assured that
the repair will be carried out by trained service technicians
using original spare parts for your domestic appliance.

Automatic programmes

The automatic programmes enable you to prepare food very
easily. You select the programme and enter the weight of your
food. The automatic programme makes the optimum setting.
You can choose from 15 programmes.

Setting a programme

Once you have selected a programme, set the oven.
Requirement: the operating mode selector must not be pushed
in.
Example in diagram: Programme 2 with a weight of
1 kilogramme.
Press the n button.
1.
The first programme appears.
FD no.
3 NJ
Replacing the glass cover
If the glass cover in the oven is damaged, it must be replaced.
You can obtain covers from the after-sales service. Please
supply your appliance's E number and FD number.
This appliance corresponds to the standards EN 55011 and
CISPR 11. It is a Group 2, Class B product.
Group 2 means that microwaves are produced for the purpose
of heating food. Class B states that the appliance is suitable for
private households.

Technical data

Power supply
Maximum total connected load
Microwave power setting
Grill output power
Hot air output power
Microwave frequency
Fuse
Dimensions (HxWxD)
­ appliance
­ cooking compartment
VDE approved
CE mark
Select the desired programme using the temperature
2.
selector.
Press the n button again.
3.
The temperature display suggests a weight.
6WDUW
220 - 240 V, 50 Hz
3100 W
1000 W (IEC 60705)
2000 W
1950 W
2450 MHz
16 A
45.4 x 59.5 x 56.3 cm
242 x 430 x 345 mm
yes
yes
3 NJ
6WDUW
3 NJ
6WDUW
37