|
|
English
2
Safety
2
Safety
2.1
Safety notes
General safety notes
This warewasher can be used by children aged 8 years and above and by persons with reduced
–
physical, sensory, or mental capabilities, or lack of experience and knowledge if they are super-
vised or have been instructed in the safe use of the machine and understand the dangers in-
volved.
Children must not play with the warewasher.
–
Cleaning and user maintenance should not be carried out by children without supervision.
–
Read the safety and operating instructions carefully.
–
Retain the operating instructions for future reference.
–
Only use the warewasher after you have read and understood the operating instructions and the
–
safety notes.
Contact Miele Customer Service Department for information on how to operate the warewasher
–
and on how it works.
Train operating personnel in handling the warewasher and point out any and all safety notes. Re-
–
peat the training sessions at regular intervals to prevent accidents.
Operate this warewasher only when it is in perfect condition.
–
A damaged or leaking warewasher may endanger safety. If malfunctions occur, switch off the
–
warewasher immediately and switch it back on only once the malfunction has been remedied.
Allow the installer or an electrician to remedy on-site water and electricity supply malfunctions.
–
Allow other malfunctions to be remedied by an authorised service technician or your dealer.
–
Once the work is complete, close the on-site water supply.
–
After finishing work, switch off the machine using the self-cleaning programme.
–
Electrical safety
Do not open any machine covers or machine parts if doing so requires tools. There is a danger of
–
electric shock.
The electrical safety of this machine is guaranteed only if it is connected to a correctly installed
–
protective circuit. It is crucial that this basic safety requirement is tested and, in case of doubt, that
the on-site installation is checked by a qualified electrician.
Miele cannot be held responsible for damage caused by a missing or interrupted protective con-
ductor (e.g. electric shock).
Work on the electrical system may only be carried out by qualified specialists. When working on
–
the electrical system, observe the electrical engineering safety rules to avoid electrical accidents:
Disconnect all power supply points.
–
Secure the machine against being switched on again.
–
Check that there is no voltage present.
–
Earth and short circuit.
–
Cover or cordon off neighbouring parts that are live.
–
If the mains cable is damaged, to prevent hazards it must be replaced by Miele, its Customer Ser-
–
vice Team or another qualified person. The mains cable must be a H07RN-F type or equivalent.
54
|
|
12020320/01; 2022-01
Operating instructions PTD 901