Table des Matières
Publicité
Maintenance
Lubrication
After each 25 hours of operation, and
after any long periods of storage,
please lubricate the locomotive's
gears with a sparing amount of
plastic-compatible, non-hardening
grease, such as PIKO #36216. Remove
the gearbox bottom cover and be
careful to keep the front and rear
wheelsets aligned with each other.
Be sure to securely re-tighten the
gearbox bottom cover screws.
Cleaning
If cleaning is necessary, use only a
mild cleaning agent (such as soap and
water) and gentle action with a soft
non-abrasive cloth or brush. Never
immerse the loco in liquid or "fl ood"
any internal parts!
Normal Wear Items
Electrical pick-up shoes, traction tires
and internal pick-up wipers will wear
with use and should be replaced as
needed.
Getting Started
Unpacking the Model
Remove the styrofoam packaging
extremely carefully to prevent
damaging accessories and attached
parts such as handrails, etc. For safe
transport, the model is delivered
from the factory with several
small parts uninstalled. See the
instructions packed with these parts
for installation. Remove these parts
before repacking the model for
transport.
Preparing for Operation
With track power "off", place the
loco on the track and ensure that all
wheels are on the rails.
Sound
The locomotive is equipped with an
analog sound system. The volume
control is accessed by gently pulling
off the front of the smokebox (the
front part of the locomotive's boiler).
For more information see the
instructions on page 10.
Smoke Unit Operation and Care
The locomotive is equipped with
a smoke generator unit. To access
the on/off switch for the smoke
unit, gently pull off the front of the
smokebox (front of locomotive boiler).
The downward position of the switch
is "on". Upward is "off". Drop about
10 to 20 drops of the PIKO smoke
fl uid (36210) into the top of the
smokestack. If over-fi lled, the smoke
generator will not work. Turn the
loco upside down to drain out excess
smoke fl uid. Caution! Never insert
any object down into the smokestack!
The heating element in the center of
the stack is delicate and easily broken
by foreign objects. Caution! Use only
PIKO smoke fl uid to preserve the life
of the smoke generator. There is no
harm in leaving smoke fl uid in the
smoke unit or in letting the the loco
run without smoke fl uid. Caution!
The smoke unit becomes very hot
during operation. Do not touch the
smoke unit. The smoke unit may also
eject bubbles of hot smoke fl uid. Keep
face and eyes away from the smoke
unit. We recommend to switch off the
smoke unit when the smoke function
will be not used for a longer time.
Initial Operation
It is recommended to let the
locomotive run at moderate speed
without a train for 30 minutes in each
direction, to properly break it in. This
will help achieve optimal performance
and longevity for the locomotive.
Track Cleaning and
Electrical Contact
Of course, the model should only be
run on smooth and perfectly clean
tracks with reliable electrical contact
to all track sections. Poor electrical
contact causes the vast majority of all
operating problems.
Please Note! Damage to Carpets
and Other Surfaces: Normal
operation of the locomotive causes
wear of mechanical parts (wheels,
electrical pickups etc.). This produces
carbonized dust, grease and oil,
which can permanently stain carpets,
wood fl oors and other materials. It
is the user's responsibility to take
proper precautions against this
damage. Wipe any grease or oil from
the track rails with a clean soft cloth.
PIKO Spielwaren GmbH, as well as
its representatives, distributors and
retailers, assume no liability for any
such damage.
Please Note!
Important Safety Precautions
• Check the power supply regularly for any
damage or problems.
• Do not use a malfunctioning or damaged
power supply!
• This model must only be operated with
one power source per circuit!
• This product is not a toy, not suitable for
personnel under 14 years of age. This
product has small parts, sharp parts, and
moving parts.
• This model must only be operated with a
safety-assured power supply with the
identifi cation!
• The power supply is not a toy!
• Disconnect the model from the power
supply before cleaning or servicing!
• Do not insert the track power connecting
wires into household "mains" voltage
outlets.
5
Publicité
Table des Matières
