Water Supply And Drain Connections - Hoshizaki FM-481ALGE Notice D'utilisation

ENGLISH
3. WATER SUPPLY AND DRAIN
CONNECTIONS
WARNING
Connect to potable cold water supply only.
Note: A plumbing permit and services of a licensed
plumber may be required in some areas.
* The connections to the mains water supply must
be made in accordance with the countries' current
requirements of the Water Supply or Water Fittings
Regulations.
* Water supply pressure should be minimum 0.05
MPa (0.5 bar) and maximum 0.78 MPa (8 bar).
If the pressure exceeds 0.78 MPa (8 bar), use a
proper pressure reducing valve. Do NOT throttle
back the supply tap.
* The icemaker drain is gravity flow, so ensure drain
pipe has an adequate pitch or fall.
* Water should drain into an open trap.
* Be sure to use the new hose-sets supplied with the
appliance. Do not reuse any old hose-sets.
II. OPERATING INSTRUCTIONS
WARNING
1. This icemaker is designed to produce and
store edible ice. To keep the icemaker
hygienic:
* Wash your hands before removing ice. Use
the plastic scoop provided (accessory).
* The storage bin is for ice use only. Do not
store anything else in the bin.
* Clean the storage bin before use (see "III.
1. CLEANING").
* Keep the scoop clean. Clean it by using a
neutral cleaner and rinse thoroughly.
* Close the door after removing ice to prevent
entrance of dirt, dust or insects into the
storage bin.
2. The use of any electrical equipment involves
the observance of some fundamental rules.
In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
* Do not damage the power cord or pull it in
order to disconnect the icemaker from the
feed network.
* Do not touch the electrical parts or operate
the operation switch with damp hands.
* This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
* Young children should be supervised
to ensure that they do not play with the
appliance.
* Do not attempt to modify the icemaker. Only
qualified personnel may disassemble or
repair the appliance.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
1. START UP
The installer will normally commission the icemaker
to start the automatic icemaking process. To ensure
continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
To start the icemaking process, check the position of
the operation switch on the operation panel:
"OFF" position - Move it to the "ON" position.
"ON" position - Press the ice button.
Ice Button Display
ICE
DRAIN
STOP
MODE
ICE STOP RESET
Once STOP Button is pushed,
ICE Button cannot start ice
production for 20 min.
Operation Panel
4
Stop Button
Reset Button
Operation Switch
Fig. 1