emerio PH-122042 Mode D'emploi page 7

Accessories pack 1 set:
- 1 x drill bit (8mm)
- 4 x rail fittings
- 4 x screw bolts
- 4 x caps for bolts
1. Mark the positions of the four holes to be drilled on the wall. (Better install the appliance in a height of
20cm – 100cm from the floor to get the best performance.)
2. Drill the holes with the drill bit.
3. Insert the plastic rail fittings into the holes.
4. Attach the appliance onto the four rail fittings through the four holes in the appliance.
5. Screw the four bolts into the plastic rail fittings.
6. Cover the bolts with the caps. It is recommended to use some glue to make the caps stick onto the bolts
firmly.
NOTE: make sure the distance between the bottom of the appliance and the floor is no less than 20cm when
the appliance is installed.
OPERATION
Plug the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power switch to
position "I". The power switch will be illuminated. The appliance is standby. Press the standby button "
run your appliance.
1. Temperature setting
Press button " + " or " - " to set the desired temperature. You can choose from 0℃ to 37℃. When you set your
desired temperature, the heater starts or stops heating automatically to maintain the room temperature. You
can long press the button " + "or " - " in the control panel for rapid adjustment.
- 6 -
" to