Oven Lights; Problem Solver - KitchenAid KFID500ESS Instructions D'utilisation

The oven lights are standard 40-watt appliance bulbs. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the Off position.
To Replace:
1. Unplug range or disconnect power.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty page in this manual and scan the code there with your mobile device, or visit http://kitchenaid.custhelp.com. In Canada,
visit http://www.kitchenaid.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
KitchenAid Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
PROBLEM
Nothing will operate
Cooktop will not operate
Cooktop cooking results
not what expected
Oven will not operate
Oven temperature too high
or too low
Oven indicator lights flash
Oven control displays
messages

Oven Lights

PROBLEM SOLVER

POSSIBLE CAUSES AND/OR SOLUTIONS
Power supply cord is unplugged - Plug into a grounded outlet.
Household fuse is blown, or a circuit breaker is tripped - Replace the fuse or reset the circuit breaker.
If the problem continues, call an electrician.
The control is set incorrectly - Touch the display area on the control panel to select a cooking surface
before selecting a function.
The cooktop control lockout is set - See "Control Lock" in the "Cooktop Use" section.
Cooktop is turned off - The Power keypad was unintentionally touched. Press POWER again. Reset the
cooktop.
Improper cookware being used - See the "Cookware" section.
Cooktop control set to incorrect heat level - See "Cooktop Controls" in the "Cooktop Use" section.
Range is not level - Level the range. See the Installation Instructions.
Delay Start is set - See the "Cook Time" section.
Control Lock is on - Press and hold START for 5 seconds to unlock.
Control is in Demo Mode - See the "Electronic Oven Controls" section. Demo Mode is used for display
models in a showroom.
Electronic oven control set incorrectly - See the "Electronic Oven Controls" section.
Oven temperature needs adjustment - See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
Power to range is turned on or restored - See "Control Display" in the "Electronic Oven Controls"
section. If the indicator lights keep flashing, call for service. See the "Warranty" section for contact
information.
Power failure (display shows flashing time) - Clear the display. On some models, reset the clock, if
needed. See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter followed by number) - Press OFF UPPER to clear the display. See
"Control Display" in the "Electronic Oven Controls" section. If it reappears, call for service. See the
"Warranty" section for contact information.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, and then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
In Canada:
KitchenAid Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
19