Saving The Remote Controls - Aprimatic Slide 230 Instructions D'installation, D'utilisation Et D'entretien

CONTROL UNIT
3.3

Saving the remote controls

ON THE BUILT-IN RECEIVER
To program the remote controls so they are recognised by
the system, follow the instructions below.
IMPORTANT! The automation must be closed before you
can start saving or cancelling settings.
At the end of programming, button 1 will give the START
command and button 2 will give the PEDESTRIAN START
command ( see fi gure beside).- unless otherwise output
channel programming.
Starting self-teach procedure
1 Press all the buttons on the fi rst
remote control to be memorised
if the receiver memory is empty;
alternatively, press all the buttons
on a remote control already
memorised. The self-teach mode
is enabled for 30 seconds.
- confi rmation: the displays
show SEED.
30"
During the programming time you can
memorise the fi rst remote control and
then any other remote controls.
At the end of 30 seconds the self-teach
mode fi nishes.
- Operation confi rmed by: The LED
switches off.
If you wish to memorise other
remote controls at this point you
must enable the self-teach once
again. To do this perform phases
using one of the remote controls
already memorised.
end
IMPORTANT NOTE:
To LEAVE programming before the 30 seconds has elapsed, press one of the buttons on the programmed remote control; all
●
the values confi rmed will be saved.
To DELETE all the programmed remote controls use the
●
1
RED button .
To DELETE an individual remote control - parameter
●
confi rm using the RED button
To export all the remote controls saved you require a plug-in memory module (see our catalogue) - parameter
●
confi rm using the RED button
1
_ before making the change the word
the display fl ashes for 3 seconds and then the word
codes) are displayed (failure).
WITH THE OPTIONAL RECEIVERS, UNICO (MEMORY SYSTEM) OR RPL-ECO
WARNING! To use the optional Unico (Memory System) or RPL-ECO receivers, unplug and remove the built-in receiver and
its antenna (see unit layout diagram).
• Plug the UNICO receiver into the connector CN2 or the RPL-ECO receiver into the connector CN1 (see
and tab.3).
• Connect the antenna and complete the remote control teach programming using the instructions supplied with the
receiver.
30"
rn
1
.
1
.
SURE
is shown on the display, if you wish to continue press the RED button again
SLIDE 230
1 ch1
2 ch2
3 ch3
4 ch4
see par. Programming.
NOTE:
These instructions are only valid for remote controls
in mode 0.
Memorising the fi rst remote control
Memorising other remote controls
30"
3 Press all the buttons on the remote control to
be memorised.
4 Press any button on the remote control.
r tr
. parameter (see Programming), confi rm the fi rst one using the
; scroll to the address of the remote control you wish to delete and
donE
is displayed (positive conclusion) or the words
- 20 -
2 1
1 3
2 Press any button on the remote
control.
- confi rmation: the displays show MEMO
for 2 seconds and then the address
of the remote control (000).
! Record the address so you
can delete this remote control as
required.
- confirmation: the displays show
memO and then the address (from
001 to 099).
! record the address.
Memorise all the other remote controls
by repeating phases 3 and 4 for each
one ( ).
record the addresses
! when the memorising procedure
is complete, the programming time
starts again.
UPLd
Er
unit layout diagram
2
4
dnLd
and ;
+ (see error