Hands Free Function - Doro AUB 300i Manuel

Hands free function

1. Press
. The hands free function will be activated and the LED indicator next to
s
the button will illuminate.
2. Dial the required telephone number. Adjust the volume using the volume control
located on the side of the telephone.
3. Speak towards the microphone located on the front edge of the telephone.
4. Press to terminate the call.
s
If you wish, you can switch between handset and hands free mode by simply pressing
or lifting the handset.
s
Please note!
Please remember that in hands free mode it is only possible for one person at a time to talk. The switch-
over between speaker and microphone is automatic and dependent on the sound level of the incoming call
and the microphone respectively. It is therefore essential that there are no loud noises, e.g. music, in the
immediate vicinity of the telephone, as this will disrupt the hands free function.
Group listening
Group listening allows anyone in the same room as the base unit to hear both parties
and follow the conversation through the base units speaker.
The ongoing call is not affected and can continue via the handset or optional headset.
1. Once the call has been connected, press
function. The LED indicator by the button will illuminate and the conversation can
then be heard through the speaker.
2. To deactivate the Group Listening function, press
Connection of a headset
An additional headset can be connected to the socket on the side of the telephone
marked . To access an incoming call or dial press
=
again. The LED next to the headset button will illuminate when activated.
Please note!
DORO original headsets are tested and adapted for this telephone. Other types and makes of headsets
may be used, though the function and sound quality cannot be guaranteed. In the worst case, these could
damage the headset and telephone. This type of damage is not covered by the telephone guarantee.
English
to activate the Group Listening
s
again.
s
, to terminate a call press
=

=