Technical Information; Declaration Of Conformity - Doro AUB 300i Manuel

English

Technical information

Within the battery compartment located on the underside of the telephone you will
find several switches, these switches determine certain technical parameters when
connecting the telephone.
IMPORTANT NOTE: These switches should only be adjusted by qualified personnel.
Recall time
The recall button timing can be switched between either 100ms (AU/UK/EU)/300ms
(FR)/600ms (NZ), using the RECALL TIME switch located on the underside of the
telephone (within the battery compartment).
EARTH/TIME (UK only)
Selection of either earth or timed loop break recall method.
PULSE/TONE
Select the required dialling type, Tone or Pulse using the PULSE/TONE switch
located on the underside of the telephone (within the battery compartment).
Message Waiting indicator
Some PBX systems use a function called Message Waiting.
The switch is located behind the battery cover on the underside of the telephone.
The MW function operates differently depending on the PBX in question. Please
contact the system controller for more information. The following four alternatives are
available: +, -, ringer indicator ( ) and high DC voltage (HV). When the telephone is
used in systems without a telephone exchange ( ) should be selected.
Connection of additional equipment
On the right side of the telephone there is a socket marked 8. This is used for
connecting additional telephone equipment to the same telephone line, e.g. a wireless
telephone, modem, etc.

Declaration of conformity

Doro hereby declares that this product, Doro AUB 300i, conforms with the essential
requirements and other regulations contained in the directives 1999/5/EC (R&TTE),
2002/95/EC (ROHS).
A copy of the manufacturer's declaration is available at www.doro.com/dofc.