Adjusting The Trigger Tension - Titan PowrLiner 2850 Mode D'emploi

SERVICING
6.4

ADJUSTING THE TRIGGER TENSION

Use the following procedure to adjust the spring
i
tension of the trigger lever on the gun holder
assembly. The trigger lever pulls and releases
the spray gun trigger when operated from the
trigger on the cart. The proper tension ensures
that the gun will shut off when the gun trigger is
released. To ensure proper tension, there should
be approximately a 1/32" to 1/16" gap between
the trigger lever and the spray gun trigger.
Always keep the trigger lock on the spray gun in
the locked position while making adjustments to
the system.
Attention
1. Using a wrench, loosen the bolt on the cable block (1).
2. Move the cable block in the appropriate direction to create
a gap of 1/32" to 1/16" between the trigger lever (2) and
spray gun trigger (3).
a. Slide the cable block toward the gun to increase the gap
between the trigger lever and spray gun trigger.
b. Slide the cable block away from the gun to decrease the
gap between the trigger lever and spray gun trigger.
3
0.8 - 1.6 mm
3. Tighten the set screw securely.
22
1
2
PL2850