Cleanup; Special Cleanup Instructions For Use With Flammable Solvents; Cleaning The Sprayer - Titan PowrLiner 2850 Mode D'emploi

CLEANUP

5
CLEANUP
The sprayer, hose, and gun should be cleaned
thoroughly after daily use.
permits material to build up, seriously affecting
Attention
the performance of the unit.
Always spray at minimum pressure with the gun
nozzle tip removed when using mineral spirits
or any other solvent to clean the sprayer, hose,
or gun. Static electricity buildup may result in a
fire or explosion in the presence of flammable
vapors.
5.1
SPECIAL CLEANUP INSTRUCTIONS FOR USE
WITH FLAMMABLE SOLVENTS
•
Always flush spray gun preferably outside and at least one
hose length from spray pump.
•
If collecting flushed solvents in a one gallon metal
container, place it into an empty five gallon container, then
flush solvents.
•
Area must be free of flammable vapors.
•
Follow all cleanup instructions.
5.2

CLEANING THE SPRAYER

1. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual, section 4.5.
2. Remove the gun tip and tip guard and clean with a brush
using the appropriate solvent.
3. Place the siphon tube into a container of the appropriate
solvent.
Use only compatible solvents when cleaning
out oil based enamels, lacquers, coal tar, and
epoxies. Check with the fluid manufacturer for
Attention
the recommended solvent.
4. Place the bleed hose into a metal waste container.
5. Set the pressure to minimum by turning the pressure
control knob fully counterclockwise.
6. Turn the relief valve to PRIME (k circulation).
7. Start the engine (refer to section 4.2).
8. Allow the solvent to circulate through the sprayer and
flush the paint out of the bleed hose into the metal waste
container.
18
9. Turn the relief valve to SPRAY (p spray).
Failure to do so
10. Trigger the gun into the metal waste container until the
11. Continue to trigger the spray gun into the waste container
12. Follow the "Pressure Relief Procedure" found in the
13. Store the sprayer in a clean, dry area.
Attention
Earth the gun by holding it against the edge
of the metal container while flushing. Failure
to do so may lead to a static electric discharge,
which may cause a fire.
paint is flushed out of the hose and solvent is coming out
of the gun.
until the solvent coming out of the gun is clean.
For long-term or cold weather storage, pump
i
mineral sprits through the entire system.
Operation section of this manual.
Do not store the sprayer under pressure.
PL2850