Installation; Work Environment Conditions; Installing Additional Modules - Corghi BR-AP Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

WARNING
The unpacking, assembly, lifting and installation procedures which follow should be
performed according to instructions.
Failure to comply with these instructions could damage the machine and put the
operator at risk.
Detach the machine from the top of the pallet, check the machine for damage caused by
transport and identify the pallet mounting points (figs.1-2-3). At this point the machine
is ready for installation.
N.B. If the machine is equipped with add-on modules, refer to the section on Installing
additional modules.
WARNING
The place where the machine is to be installed must conform to applicable safety at
work regulations.
IMPORTANT: for correct, safe use of the equipment, a lighting level of at least 300 lux
must be ensured in the place of use.
WARNING
The machine must not be installed in an open area.
Move the machine to the designated installation site, respecting the minimum distances
reported in Fig. 4.
- Relative humidity: 30 ÷ 95% without condensation
- Temperature 0°C - +55°C
WARNING
The machine must not be operated in potentially explosive atmosphere.
WARNING
Install the unit at least 60 cm. from any heat source (Fig. 4).
Level the machine using the adjustable feet (5 fig. 7).
Hook-up to the electric mains (see the section on "Electrical and Pneumatic hook-up").
Remove the left side panel (1 Fig. 7) on the BR base module. Slacken the nuts under the
shoulder (2 Fig. 7), rotate the plates (3 Fig. 7) outwards by 90° and tighten securely. Fit
the additional module on top of the base module, remove the feet (5 Fig. 7) and place
shoulder 4 over the plates (3 Fig. 7).
26

INSTALLATION

Work environment conditions

BR base module

Installing additional modules

Operator's manual BR-AP/AP-S

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Br-ap-s

Table des Matières