Installation - Corghi EM9980 Manuel D'utilisation

Packaging weight (kg/lb): ............................ 43/95
Weight of electrical/electronic
components (kg/lb):. ................................... 10/22
- The machine must be stored in an
environment meeting
requirements:
• relative humidity ranging from 20% to 95%;
• temperature ranging from -10° to +60°C.
CAUTION
Do not stack more than two packs to avoid
damaging them.
The machine may be moved for installation or
for subsequent relocation as follows:
- With a crane, using special equipment that
holds the machine at the designated lifting
points (Fig. 2).
- By inserting the forks of a lift truck under the
machine so that the centre of the forks corre-
spond approximately to the centre line of the
body (Fig. 3).
EM9980 - Operator's manual
the following
Always unplug the power supply cable from the
socket before moving the machine.
Never apply force to the wheel spin shaft when
moving the machine.
Carry out the unpacking, assembly and installa-
tion operations indicated below with great care.
Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the original packing materials after
2
positioning them as indicated on the packaging
and keep them intact so that the machine can
be safely shipped at a later date if necessary.
The place where the machine is to be installed
must conform to applicable safety at work
regulations.
In particular, the machine must only be installed
and used in protected environments where there
is no risk of dripping onto it.
The floor must be strong enough to support a
load equal to the weight of the equipment plus
the maximum load allowed. The support base on
WARNING
CAUTION

INSTALLATION

WARNING
WARNING
3
UK
43