Dometic RMD 10 Notice D'utilisation page 33

RMD 10
ERROR type fault messages
All faults of the ERROR type must be reset manually:
➤ RMD 10.5T, RMD 10.5XT: Press the control knob for 2 seconds.
➤ RMD 10.5, RMD 10.5X, RMD 10.5S, RMD 10.5XS: Press
✓ A beep sounds.
✓ The error has been reset.
RMD 10.5,
RMD 10.5T, RMD 10.5X,
RMD 10.5XT RMD 10.5S,
RMD 10.5XS
E03
E07
E08
E09
E12
E13
EN
Fault
No connection between
power module and display
No cooling capacity in gas
mode
No cooling power in AC
mode
No cooling power in DC
mode
Gas valve check error
Internal communication error Gas operation not possible.
Troubleshooting
for 2 seconds.
Solution
Contact an authorized customer
service.
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
Gas operation is not possible.
Reset the error.
Contact customer service if this
error occurs again.
Reset the error.
Contact customer service if this
error occurs again.
33