Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
out by professionals is declined.
Fire safety Precautions
In case of fire, use carbon dioxide (CO
Do not use water or dry powder extinguishers.
4
MaCHine installation
For your safety and that of others, strictly follow the
"safety regulations" detailed in section 3.
4.1 Packaging of Machine
The original packaging has been designed to protect the
machine during transportation.
We recommend keeping the packaging carton for
possible future transportation.
4.2 installation instructions
Before installing the machine, observe the following
safety precautions:
• Place the machine in a safe place;
• Make sure children cannot play with the machine;
• Avoid placing the machine on very hot surfaces or
near open flames.
The coffee machine is now ready to be connected to
the power supply.
4.3 Power supply Connection
electric power may be very dangerous! it is
therefore necessary that the safety regulations
be carefully respected.
Do not use faulty power cords! Faulty cords
and plugs must be replaced immediately in
authorized customer service centers.
The voltage of the appliance has been pre-set by the
manufacturer.
Check that the voltage matches the references on the
label, at the bottom of the appliance.
• Check that the power button is set on "0" before
connecting the machine to the power supply.
• Only connect the plug to a socket with suitable
voltage.
4.4 Filling the Water tank
• (Fig.1) - Remove the water tank. An automatic device
lifts the water suction pipe.
) extinguishers.
• (Fig.2) - Rinse and fill the tank with fresh drinking
2
water, making sure not to overfill it.
• (Fig.3) - Reinsert the tank into its housing. Press
down firmly to activate the automatic device which
immerses the suction pipe in water.
Fill the tank with only fresh, non-sparkling,
drinking water.
Hot water or any other liquid may damage the
tank. Do not switch on the machine with empty
tank: Make sure there is enough water in the tank.
4.5 Priming the Water Circuit
Before starting up the machine, after a long period of
inactivity, and whenever the tank is empty, the machine's
water circuit must be primed.
• (Fig.4) - Switch on the machine by means of the power
button - "I" position.
• (Fig.5) - Place a container under the cappuccinatore.
Open the "hot water/steam" knob by turning the knob
counter-clockwise.
• (Fig.6) - Press the brew button.
• Wait until a steady jet of water flows out from the
cappuccinatore.
• Press the brew button again.
• (Fig.7) - Close the "hot water/steam" knob by turning
it clockwise.
• Remove the container.
The machine is now ready to brew coffee and dispense
steam. Please see related sections for operating
details.
(Fig.48) - Cups can be warmed on the cup-
warming surface.
When the machine is on, the cup-warming
surface is always on. Please be very careful
when you are around this area: Danger of slight
burns.
• 21 •
Publicité
Table des Matières
