Meta System DEFCOM 3.1B Manuel Utilisateur page 6

13. 'OVERRIDE' EMERGENCY CODE
If a remote control is lost, stolen or damaged, it is possible to disarm the alarm system with a 5
digit emergency code called the 'OVERRIDE' CODE and this code is found on the label applied
on the alarm central unit body.
Remove the label from the alarm unit body and places it on the dedicate plate that you can
fi nd in the accessory bag, this plate must be kept in a safe place and not with the motorcycle.
The procedure is operational only after the initial immunity phase is over, and if the alarm fun-
ctions are operational, alarm cycles will be triggered while the override code is inserted.
Perform the following procedure.
With armed alarm system activate the instrument panel and immediately deactivate it; the LED
will turn ON, turn off and then start to fl ash after 2 seconds.
"OVERRIDE"
EMERGENCY CODE
WITHIN 10 SEC.
x1
WARNING: if the standard 'OVERRIDE' CODE length (5 digits) will be change in 3 digits the
alarm unit disarms after entering the third digit instead of the fi fth one.
If 3 attempts to insert the wrong code are detected, the central unit will be blocked for 10 mi-
nutes in order to prevent attempts to search for the code.
14. CUSTOMISING THE 'OVERRIDE' CODE
It is possible to customise the 'OVERRIDE' CODE so that it is easier to remember in case of
emergency. The 'OVERRIDE' CODE customising and the length reduction in 3 digits can be
performed by the installer only using the PRG007 V3 PROGRAMMER.
DEFCOM 3.1B User Manual
ALARM
IN ACTIVE
PHASE
(AFTER 26 SEC.)
( WITHIN 2 SEC. )
WITHIN 10 SEC.
x3 x2
WITHIN 10 SEC. WITHIN 10 SEC.
x1 x2
DISARM
OK
13