Service Mode; Stop Mode - Meta System DEFCOM 3.1B Manuel Utilisateur

8. PROTECTION BY THE ALARM SYSTEM
The alarm central unit protects the motorcycle against being started and an alarm cycle will be
triggered every time:
• The ignition key is turned ON
• An attempt is made to remove or move any part of the motorcycle which is protected by
specifi c switches (for example if the seat or the storage compartment is opened...)
• The motorcycle is moved
• The alarm system's supply cables are disconnected or cut or if the motorcycle's battery is
disconnected.
It is possible to trigger a 10 second alarm cycle by pressing the B BUTTON on the remote con-
trol. This alarm cycle can be interrupted by pressing the same button again.
If needs excluding the alarm system for a time period, it's possible enable the SERVICE MODE
modality using its remote control.
To enable the SERVICE MODE turn ON the motorcycle's key and immediately after press hold
the A BUTTON of remote control at least 6 sec., the feature enabling is indicated by the LED
fl ashing very fast when the motorcycle's key is ON.
To disable the SERVICE MODE turn ON the motorcycle's key and immediately after press hold
the A BUTTON of remote control at least 6 sec., the feature disabling is indicated by the LED
goes OFF.
11. AUTOMATIC SYSTEMS TO PREVENT
This product has 2 diff erent timed operation options to protect the vehicle battery (STOP
MODE and DEEP SLEEP MODE) and an additional system to fast shut off if the battery voltage
level goes down than 10,5V.
DEEP SLEEP MODE
It is activated 5 days after the system was armed by remote control or automatically (passive
arming) if no alarms were triggered in this time.
The behavior of this operation option it's very similar than the STOP MODE and the mainly
diff erence it's the vehicle protection that stay active during the DEEP SLEEP phase.
To exit from DEEP SLEEP MODE, turn the ignition key ON: the siren will emit a series of BEEP
sounds. Press the remote control within 20 seconds of the BEEPS to disarm the alarm system.
If the remote control is not pressed within 20 seconds, an alarm cycle will be triggered.

STOP MODE

(LIMITING CURRENT CONSUMPTION WITHOUT ALARM FUNCTIONS)
The alarm system automatically switches off in order to limit the consumption of current in
the motorcycle's battery, automatically excluding the alarm functions but maintaining the
immobilization of the engine: in this condition current consumption is nil. STOP MODE is
activated 5 days after the system was armed by remote control or automatically (passive
arming) if no alarms were triggered in this time or if the motorcycle's battery is almost fl at
(battery voltage level under 10,5V).
To exit from STOP MODE, turn the ignition key ON: the siren will emit a series of BEEP soun-
ds. Press the remote control within 20 seconds of the BEEPS to disarm the alarm system. If the
remote control is not pressed within 20 seconds, an alarm cycle will be triggered.
DEFCOM 3.1B User Manual
9. PANIC

10. SERVICE MODE

VEHICLE BATTERY DISCHARGE
(LIMITING CURRENT CONSUMPTION WITH ALARM FUNCTIONS)
11