Meta System DEFCOM 3.1B Manuel Utilisateur page 5

12. MAIN PROGRAMMABLE FUNCTIONS
It is possible to set some alarm functions to adapt the alarm system to the motorcycle and
its driver's needs. All possible set-up are described in the table below where in bold are hi-
ghlighted the factory set-up.
FUNCTION
Passive arming
Passive arming type
Horn alarm output
Buzzer Arm./Dis.
Direction indicators
Arm./Dis.
Alarm line
Yellow/Green wire
Alarm line
Purple wire
Remote control
buttons
Panic alarm
Override Code length
Type of low
consumption mode
Activation timing of
low consumption
mode
Use only the PRG007 PROGRAMMER V3 to select the various functions of the product. Sof-
tware updates for the PRG007 PROGRAMMER V3 and information about the programmable
functions are available ONLINE in the TECH AREA/VEHICLES AREA of the www.metasystem.it
website.
To enable or disable the buzzer during the alarm Arming/Disarming execute the
following procedure:
• Enable the SERVICE MODE and after press 6 time the A BUTTON of remote con-
trol, one Beep will confi rm the buzzer change.
• Then restore the normal operation of the alarm unit by deactivating the SER-
VICE MODE.
12
OPTION "A"
Enabled
Only immobilizer
Continuous
Enabled
Enabled
Active if removed the
earth connection
Active if removed
the earth connection
Button "A":
Arming/Disarming
Enabled
Only fi rst 3 digits
Stop Mode
5 days
OPTION "B"
Disabled
Immobilizer and
switches alarm
Alternated
Disabled
Disabled
Active with
earth connection
Active with
earth connection
Button "A": Arming
Button "B": Disarming
Disabled
5 digits
Deep Sleep Mode
10 days
DEFCOM 3.1B User Manual
Immobilizer,
switches alarm
and tilt sensor
Arm./Dis. switch
input using CARD