Priority-Channel Select; Scan Revert - Kenwood TK-5720 Mode D'emploi

PRIORITY-CHANNEL SELECT

If the Priority channel has been set as Operator Selectable by your dealer, you
can reprogram the Priority channels.
1 Select your desired zone and channel.
2 Press the key programmed as Priority-channel Select.
3 Press / to select "NORMAL", "PRIORITY 1" (
"PRIORITY 1&2" (
4 Press to save the setting.

SCAN REVERT

The Scan Revert channel is the channel selected when you press the microphone
PTT switch to transmit during scan. Your dealer can program one of the following
types of Scan Revert channels:
• Selected: The last channel selected before scan.
• Selected + Talkback: Same as "Selected", plus you can respond to calls on
the channel at which scan is paused.
• Priority 1/ Priority 2: The Priority channel (either Priority 1 or Priority 2).
• Priority 1 + Talkback/ Priority2 + Talkback: Same as "Priority 1/ Priority 2",
plus you can respond to calls on the channel at which scan is paused.
• Last Called + Selected: Same as "Selected + Talkback", plus you can
respond on the last channel on which you received a call after scan has
resumed.
).
), "PRIORITY 2" ( ), or
13