Safety Rules; Camera Installation - Videotec HOV32K1A100 Manuel D'instructions

Camera housing and accessories

SAFETY RULES

• Connect the unit to a power supply
corresponding to the one indicated on the rating.
• The outlet must be adequately ear thed
according to the regulations in force.
• Before moving or carr ying out technical
operations on the unit, isolate and disconnect
it from the power supply.
• Do not use worn or damaged power cords,
since they represent a serious risk for the
user's safety.
• The installation of the unit (and the associated
equipment of which the unit is part) must be
carried out by adequately skilled technical
personnel.
• Do not use the device in areas containing
inflammable substances.
• Make sure that the unit is mounted securely
using fixings adequate for the weight and the
mounting surface.
• The unit is considered switched off only when
the power supply is isolated and the
connecting cables to the unit are disconnected
from the supply.
• Keep this manual safe for future reference.
DESCRIPTION
Modern and innovative waterproof housing, made
of die-cast aluminium and ABS. The side opening
greatly simplifies the access to the camera, to the
optics and to all connections.
This housing is compatible with 1/2", 1/3" and
1/4" cameras fitted with fixed focus or small
zoom lenses available on the market.
It is designed to be assembled with the cables
passing inside the bracket or with external wiring
using two PG9 and one PG11.
If the cable glands are fitted, IP66 protection level
is guaranteed, except for the models with installed
cooling device where the protection level is IP44
(Fig. 10).
A wide range of accessories is available allowing
indoors or outdoors installation.
The installed cooling device is made up of a
thermostat fan, which, through two air intakes,
eliminates the excess heat inside the housing
(Fig. 11).
This means the housing can be installed even in
ver y hot surroundings, where the inter nal
temperature must be kept within the operating
limits for the camera.
Tu r n
b e f o r e
operations.
Available accessories
Depending on the configuration provided, the
housing can be used with:
- Sunshield
- Heater kit
- Power supply kit
- Support circuit with tamper switch
W i n d o w a n d
cleaning
Wash with neutral soap and water.
Avoid ethyl alcohol, solvents,
h y d ro g e n a t e d
s t ro n g a c i d a n d a l k a l i . S u c h
products may irreparably damage the
plastic surfaces.
INSTALLATION
How to open the housing
To open the housing, loosen the two screws on the
side (Fig. 1), turn the cover and the upper half of
the body about the opening hinge axis. In this
way there will be easy access to the inside of the
housing.

Camera installation

This section describes how to install the camera
inside the housing. It should be remembered that
the power supply can be taken from the circuit
supplied after making sure it is correct one.
1. Open the housing as described before.
2. Extract the internal support slide by partially
loosening the fastening screws (Fig. 2, point 1).
8
o f f t h e p o w e r
p e r f o r m i n g
p l a s t i c c o v e r
h y d ro c a r b i d e ,
ENGLISH
a n y