Videotec HOV32K1A100 Manuel D'instructions page 11

ENGLISH
main supply voltage phase (Fig. 13).
3. Connect terminal C, on terminal J1, to the
main supply voltage neutral.
4. Connect terminal P, on terminal J1, to a button
that, when connected in turn to the main
supply voltage phase, will start the wiper
system when pressed. When the button is
released the wiper blade will return to the rest
position.
If you have a receiver with the Wiper control
f u n c t i o n , c o n n e c t t h e S W, P E R a n d C O M
terminals respectively to terminals S, P and C on
terminal J1.
The manufacturer declines all
responsibility for any damage
caused by an improper use of the
appliances mentioned in this manual.
Furthermore, the manufacturer reserves
the right to modify its contents without
any prior notice. The documentation
c o n t a i n e d i n t h i s m a n u a l h a s b e e n
c o l l e c t e d w i t h
manufacturer, however, cannot take any
liability for its use. The same thing can be
said for any person or company involved
in the creation and production of this
manual
11
Camera housing and accessories
g r e a t c a r e , t h e