Footrest Adjustment; Maintenance And Cleaning - AneX m/type PRO Manuel D'entretien

Footrest adjustment

To lower the footrest, simultaneously press the
buttons on both sides of the footrest and adjust
it to the required height (Fig. 33). The footrest
can be lifted without pushing any buttons.
Seat unit's security bumper
The seat unit is equipped with a bumper, that
has a function of additional protection and
comfort. To mount the bumper, insert it into
the holes on both sides of the seat one by one
(Fig. 34). If you need to remove the bumper,
press the buttons and slightly pull the handle
on (Fig. 35). You may also remove just one side
of the bumper, while leaving the other one on
the seat unit.
Safety belts
The seat of the stroller unit is equipped with a
5-point safety belts (2 shoulder parts, 2 lumbar
parts and the main one at crotch). To secure
the child, connect the ends of the shoulder
straps to the lumbar ones and insert them
into the lock on the main seat belt (Fig. 36).
After that tighten the straps. The length of
the seatbelts can also be adjusted. If you want
to shorten them, pull the plastic regulator up
while holding the upper part of the seatbelt
(Fig. 37). In order to extend the seatbelts, put
the plastic regulator down along the belt. When
you need to unfasten the seatbelts, press the
button and remove the locks from the clamp.
If you want to change the position of the upper
seatbelts, first dismantle the textile kit from the
top of the backrest, then remove the seatbelts
and change their position (Fig. 38). Put the
fabric part back in its normal position. For
convenience there is a button in the internal
part of the shoulder pads which serves to
attach them to the belt, thereby preventing
them from sliding along the belt (Fig. 39).
Child car seat
You can mount a child car seat on the frame
of this stroller. For this, insert the adapters into
the adapter compartment on the frame (Fig. 40)
and then attach the car seat to the adapters
until you hear a distinctive sound. To remove
the adapters from the frame, press the adapter
buttons (Fig. 41). To remove the child car seat
from the adapters, press the buttons under the
fabric on both sides of the seat at the same
time (Fig. 42). Both the adapters and the child
car seat are locked automatically. The car seat
can be fixed with the help of standard car seat
belts as well as with the ISOFIX locking system.
Please read the manual carefully before using
the car seat.
Installing additional
accessories on the frame
There are special fasteners for the Anex
cup holder located on both sides of the frame.
The stroller is also equipped with a shopping
basket, which is attached to the bottom part
of the frame with the help of a zipper (Fig. 43).
A backpack for parents is also provided.

Maintenance and cleaning

Please ensure that the stroller is kept clean and
dry (both the coating and the frame). In case
the stroller gets wet or dirty, it should be dried,
and the metallic parts cleaned with a dry cloth.
You have to protect the stroller from any kind
of dirt (sand, dust, etc.), in case it happened
the stroller needs to be cleaned as soon as
EN
TM
9